When it comes to common troubleshooting for rebar thread rolling machine,there are several issues that can occur.Here are some common problems and their potential solutions:
1.Machine tool repair and daily maintenance precautions
Check whether the power supply is turned off before the machine tool is repaired. The new machine tool should be injected with oil before use, and regularly check the replacement of the oil in the reducer, the use of the process should be irregularly in the guide shaft screw and other parts of the lubricating oil, the water tank in normal use should be cleaned once every 15 days to extend the service life of the pump.
2.Where should we check if there is no thread, swelling and mess in the process of using the machine tool?
No thread should be checked whether the gasket pad is wrong, whether the direction of the roller is the same, and whether the eccentricity of the eccentric shaft is the same.If the wire rises, check whether the locking screw after the flange is tightened, whether the ribbing is suitable, and whether the eccentric shaft is worn Filaments should be checked whether the roller should be replaced.
3.Retracting effort
Check whether the cutting fluid is added to the cooling water, whether the tool body is sliding, and whether the two reaping tool blocks are parallel
4.It can’t rise
Check whether the lock ring screw on the positioning disc is too long, whether the screw on the front axle cover is dropped, and whether the expansion arm is suitable
5.Cause of trip
Check whether the power cord is broken, whether the motor is burned or flooded, whether the pump is broken or flooded, and whether the power cord is connected
6.There is little water in the pump
Whether there is water shortage in the water tank, whether the water outlet hole in the wire rolling head is blocked, whether the steering of the pump motor is correct, and the phase reversal of the power line of the pump motor
7.What is the reason why the rolling wire wheel cannot be adjusted
Whether the six screws connected with the flange and the rear shaft cover are all loosened, and whether there is foreign matter in the adjusting gear and tooth ring
8.Reducer water into what accessories
Replace the two water seals in the water jacket and the oil seals in the reducer flange
Post time: Dec-12-2023